DUK Pullcord switch LHPEw-10/2-B
NEW Item
Manufacturer Part Number: LHPEw-10/2-B
Contacts NC 2, NO 2
Contactsurface Silver
Pullcord switch
- Impact resistant BMC enclosure optional cast iron
- IP67
- Up to 2 x 50 metre pull cord
- Up to 4 contacts NC plus 4 NO
- Snap action
- Direct opening, positive drive
The design of these pull cord switches considerates heavy duty service. Enclosures made of most stable, impact resistant, thick walled glass fibre-reinforced polyester (BMC) or optional of cast iron are the best guarantors for long year reliable service. Both types areat least IP67-protected (water- and dust proof). Pull cord switches of this type are for double-sided rope mounting with a maximum rope length of 2 x 50metres. Pulling on one of these ropes operates all contacts via snap action mechanism independent on the direction of pulling. Simultaneously with this operation the latching is being effected automatically.
The status (operated/not operated) as well as the direction from where the switch has been operated is indicated by the position of the latched actuation lever. The direct opening system (positive drive) forces the snap action NC contacts into open positionunder all circumstances. These switches will be equipped with up to 4 micro switches. Each micro switch incorporates either 1NC plus 1NO contact or alternatively 2NC‘s. They commutate independent on the direction of pull cord actuation.
The contacts are made of silver, a gold coating is optional. The contact surfaces are wiping: with every actuation,they are cleaning themselves.
Each micro switch is certified by VDE and CCC and is bearingtheir signs. The switches are approved also to bear the Eurasian EAC sign. Unrivalled long pull cord travel and the high actuation force prevent unwanted stops caused by solids fallingonto thepull cord. Guarantors for an extended, reliable life time are most important details like sealing rings protecting the shafts, an extra hard rubber gasket in the lid, shafts and screws made of stainless steel.
Technical Data
- According to standards EN 60 947-5-5 / EN60204 / EN13850 if equipped and proper installed with 2 pretensioning springs type SPF-W
- Approval of micro switches Reg.Nr.: 6671, 6827, 40026213
- Approval: EAC
- I th (thermical current) 10A
- Rating Silver: 400VAC 6A / 230VAC 8A / 24VDC 10A / 80VDC 3 A
- Minimum Current Gold: 1mA bei 6VDC
- Utilization Category
- Silber: AC-15 230V 1A DC-13 110V 0,5A
- Gold: AC-12 230V 250mA DC-12 110V 250mA
- Ui Rated Insulation Voltage 400V
- Uimp Rated Impulse 4kV
- Terminals Screw, each terminal clamp 1 or 2 cables, each max 2,5mm²
- Protection IP67 acc. EN 60529, at least IK08 acc. EN 66262
- Cable Entries 2 x M25-threaded, EXW closed by IP67-protecting plugs
- Housing Material
- Fibreglass Reinforced Polyester BMC (types LHP….)
- Cast Iron (LHM…)
- Colours
- yellow RAL 1003,
- optional red RAL 3000
- Coating Cast iron 2 layer 2-component PU / BMC none
- Weight / Mass approx.
- 2.2 kg (LHP...),
- 6 kg (LHM...)
- Mounting position free
- Ambient operation temperature - 40°C up to +85°C (-55°C on request)
- Basic values for calculation of SIL or PL according EN 13849 and IEC 61508: B10 = B10d 80000 cycles
